We have been experiencing very high demand for our products over the past three months. we are working hard to meet the increased demand. All orders are fullfilled in the order received.

0

Your Cart is Empty

How do I open the DAC1 or DAC2?

October 07, 2014

    1. Remove 4 screws from each side of the cover.
    2. Lift the cover upward.

    Caution: Do not remove the internal safety cover that encloses the AC power entry.

      Note: The cover is designed to fit tightly against the side of the unit.

       



      Also in FAQ

      Is there any benefit to using a software upsampler?
      Is there any benefit to using a software upsampler?

      March 23, 2015

      In some cases, upsampling will improve the output of your D/A converter. The low-pass filters incorporated into the upsampling process will essentially replace the filters in your D/A converter. If the upsampling software has better filters than those built into the D/A, then you may see an improvement.

      Read the full answer here...

      Read More
      What is the best or recomended setting for connecting a Benchmark DAC1 PRE directly to a set of active speakers?
      What is the best or recomended setting for connecting a Benchmark DAC1 PRE directly to a set of active speakers?

      October 10, 2014

      Read More
      Can the ADC1 provide 16-bit output?

      October 06, 2014

      The ADC1 converters have the ability to provide 16-bit outputs on the auxiliary output while providing high-resolution outputs on all other outputs. The 16-bit output mode is always TPDF dithered. The auxiliary output can be set for 16-bit operation or 24-bit operation. All other outputs are always 24-bit. 

      The ADC1 converters also have the ability to output up to 3 different sample rates simultaneously. The USB, Main, and Aux outputs are independent. The sample rate of the USB output is controlled by the computer.

      Read the full answer...

       

      Read More