AHB2 Bench Test - Bascom H. King, Everything Audio Network
AHB2 - "Lowest Noise and Distortion Power Amp I Have Measured"
"The new Benchmark AHB2 is the result of considerable research and patents on its resultant circuitry. The intent was to make it an ultra low distortion design. I would have to say they succeeded as it is the lowest noise and distortion power amp I have measured and I have measured a LOT of power amps in my career."
"The S/N ratio was about 131.6 dB. Pretty impressive, and this is the lowest output noise level I have seen in any power amplifier I have measured! (Editor's note: Benchmark measured 3 dB better when input was terminated with 60 Ohm impedance input.)"
"When connected in bridge mode, power was close to 400W into an 8 ohm load."
"Overall HF bandwidth is quite high with a 3 dB down point of 200 kHz or more."
"AC line draw at idle was 20W with a power factor of 0.46 and 0.37A."
"Input impedance was an easy to drive 47K at 1 kHz."
- Bascom H. King, BHK Labs
Also in Reviews
Benchmark System Review - Ricky Dasler, Living Sound, New Zealand
"With over 40 years as an audiophile and more than half those years as a hi-fi retailer, I feel I’ve finally put together a stereo that ticks all my sonic boxes. Those being in order of priority, dynamics, scale, tonal accuracy, fatigue free resolution and soundstage."
"For the last 25 years I’ve been fortunate to have a dedicated listening room. I use acoustic treatments from Real Traps, Vicoustic and Primeacoustic."
"My Benchmark components consist of the DAC3 B (connected to a Naim NDS streamer), LA4 line amplifier and two AHB2 power amplifiers run in bridged mono mode. All cables are Benchmark too."
"The Benchmark gear in my system has brought what I have wanted in my list of sonic priorities as listed above and then some. They have delivered way beyond what I thought could be possible in my system in my room."
"I’m delighted and stunned daily as my vast music collection comes to life on a whole new level."
- Ricky Dasler, Living Sound, Nelson New Zealand.
Benchmark Converters at Abbey Road - Geoff Pesche
"What are the Latest Advancements in Mastering?"
"Geoff Pesche weighs in on how the mastering team at Abbey Road Studios achieve first-class results." - Mix with the Masters
"The biggest sonic improvement in mastering in the last 5 or 6 years is D/A and A/D converters and that's very very important - what you have at the front and the back of the chain."
"We use fairly new Benchmark converters front and back."
"Abbey Road like a uniformity between the rooms so all of the rooms have the same A/D and D/A conversion."
- Geoff Pesche, Mastering Engineer, Abbey Road Studios
DAC3 Review - Alan Sircom, hi-fi+
"A Damn Good, No-Frills Digital Converter"
"Benchmark Media Systems’ no-nonsense approach to all things audio is rare today."
"Uniformly Good"
"This is a DAC that’s uniformly good at everything. It resolves well, has good imaging properties."
"It makes a balanced, honest sound that allows you to sit and listen to music for hours. That is what makes Benchmark’s products consistently popular with audio engineers. You don’t want ‘bright’ if you sit at a mixing desk 10 hours a day. "
"Leave No Trace"
"It also has the latest version of Benchmark’s jitter attenuation system (UltraLock3) and doubles down on the digital demon with its multi-mode asynchronous USB system."
"Benchmark also uses the distortion compensation facilities built into the ESS chip to reduce second and third order distortion."
"The net result is a DAC that delivers lower distortion, lower noise, less passband ripple, faster signal switching and locking onto signals and a more linear frequency response."
"The Benchmark Media Systems DAC3 B is very much in the ‘leave no trace’ school of good audio."
- Alan Sircom, hi-fi+